Why does my Litter Robot keep stopping during cycle?

Have you ever found your Litter-Robot stopped in mid rotation and possibly with the red light blinking? This could be a sign that your cat sensor needs adjustment. … This problem can be easily fixed by simply adjusting the Cat Sensor.

How do you force a Litter-Robot to cycle?

Press the Cycle button. The unit should cycle and return to Home with a solid blue light. Adjust your cat sensor by pressing the Reset button. Test CATS by pressing on the globe just above the entrance in a forward and downward motion.

Why does my Litter-Robot keep getting stuck?

Check for stuck litter, especially if you recently cleaned your unit (leftover moisture may have interacted with the litter). If you see debris or suspect there is litter caked behind the screen, you will need to clean the Globe (the screen should not be bent outward to clean behind).

How long does it take the Litter-Robot to cycle?

After your cat leaves the Globe, the Litter-Robot automatically performs a Clean cycle. The patented sifting system separates the clumps from the clean litter and deposits them into the Waste Drawer below. It takes about 2 ½ minutes. You can also press the Cycle button to start a Clean cycle.

THIS IS UNIQUE:  How do I reset Roomba 880?

How do you reset a cat’s sensor?

To reset the Cat Sensor, press Reset when the unit is at the Home position and the control panel displays a solid blue light. Press the Reset button firmly and quickly, then watch for the blue light to flash to confirm you have successfully reset the Cat Sensor.

Why does my Litter-Robot say timing?

The Wait Time is the elapsed time starting from when your cat exits the Globe until the unit starts a Clean cycle. It can be set for 3, 7, or 15 minutes. The default Wait Time setting is 7 minutes.

Where is the sensor on Litter-Robot?

The Litter-Robot is equipped with infrared emitters and sensors located above the Waste Drawer that check if the drawer is full each time the Globe returns to the Home position.

What does over torque fault mean?

The “over torque fault” means that the there could be a motor obstruction, too much weight in the globe, or the unit is cycling 360 degrees. The most likely scenario is that there’s too much weight in the globe. Make sure the litter level is at, or just below, the raised fill line.

How long is Litter-Robot warranty?

The Litter-Robot is backed by an 18-Month Full Warranty and you have the option to extend it for another 18 months for three years of coverage. During the warranty period, AutoPets will repair your Litter-Robot (and even cover shipping costs within the continental United States).

How do you clean the sensor on Litter-Robot?

We recommend cleaning the unit as needed. Simply wiping it down with a damp paper towel will keep your unit looking new and clean. Using a mild detergent is recommended. Do not use bleach on the units, as this can cause the plastic to degrade.

THIS IS UNIQUE:  Is big data part of artificial intelligence?

What happens if you overfill Litter-Robot?

Fill the globe with approximately 8-10 pounds of litter, until it meets the raised “fill line” on the black rubber globe liner when spread flat. If there is too much litter in the globe, it will be expelled into the waste drawer during the first few cycles.

How often does Litter-Robot need to be changed?

We recommend emptying and cleaning the inside of the globe every one to three months. Learn how to clean your Litter-Robot: 1. Press the Empty button to cycle the globe clockwise, which will allow the litter to fall through the waste port and into the drawer for easy disposal.

How often do you need to replace cat litter?

Twice a week is a general guideline for replacing clay litter, but depending on your circumstances, you may need to replace it every other day or only once a week. If you clean the litter box daily, you might only need to change clumping litter every two to three weeks.

Categories AI