You’ll need to change the waste drawer liner about once every 7-10 days (with one cat) and add litter as needed.
How long does it take the Litter-Robot to cycle?
After your cat leaves the Globe, the Litter-Robot automatically performs a Clean cycle. The patented sifting system separates the clumps from the clean litter and deposits them into the Waste Drawer below. It takes about 2 ½ minutes. You can also press the Cycle button to start a Clean cycle.
How does the Litter-Robot know when to cycle?
The Litter-Robot relies on the Cat Sensor to know when your cat is inside the Globe and when it’s time to run a Clean cycle. Here’s how it works: Each time the unit is powered on and at the end of each cycle, the Cat Sensor measures the weight of the unit to use as a baseline.
How do you force a Litter-Robot to cycle?
With the unit powered ON, unplug the power supply from the base and wait 10 seconds. Plug the unit back in, allow it to complete the start-up cycle, and follow the steps below. Hold the Cycle button for 5 seconds. Both blue AND yellow lights are now on.
What triggers the Litter-Robot?
The Litter-Robot senses the weight of your cat to know when it enters and exits the globe, which triggers the countdown timer and cleaning cycle. Kittens and small cats that weigh less than 5 pounds may not be heavy enough to trigger the cat sensor.
Empty Button + [Wait Time Setting]
Press and Release: Empties all litter from Globe into the Waste Drawer. Press any button to return the Globe to home position. Press and Hold: Holding the Empty button will enter Wait Time Setting mode indicated by one of the LEDs flashing.
How much does it cost to fill a litter robot?
Fill the globe with approximately 8-10 pounds of litter, until it meets the raised “fill line” on the black rubber globe liner when spread flat. If there is too much litter in the globe, it will be expelled into the waste drawer during the first few cycles.
How often do you change Litter-Robot filter?
We recommend that you change the carbon filters every three to four months depending on how frequently your Litter-Robot gets used. This is really up to personal preference. If you are noticing a stronger odor coming from the unit, it may be time to change the carbon filter.
Why does my Litter-Robot say timing?
The Wait Time is the elapsed time starting from when your cat exits the Globe until the unit starts a Clean cycle. It can be set for 3, 7, or 15 minutes. The default Wait Time setting is 7 minutes.
Why does my Litter-Robot keep saying its full when its not?
Debris may cause the DFI to indicate a full drawer regardless of the waste in the drawer. Once you are done cleaning your unit, let it dry fully and then reassemble it.
Why does my Litter-Robot get stuck mid cycle?
Have you ever found your Litter-Robot stopped in mid rotation and possibly with the red light blinking? This could be a sign that your cat sensor needs adjustment. … This problem can be easily fixed by simply adjusting the Cat Sensor.