How do you reset the WiFi on a Litter Robot?

How do you reset the WiFi on Litter-Robot 3?

Please follow the steps below.

  1. Open your app.
  2. Go to “Remote” and click “Delete my Litter-Robot.”
  3. Completely close the Litter-Robot app.
  4. Reset your Litter-Robot by unplugging it from the base while the unit is powered on.
  5. Wait 15 seconds, plug it back in, and allow it to cycle until the blue “Ready” status lights up.

How do I hard reset my Litter-Robot?

HARD RESET

  1. Hold the Cycle button for 5 seconds. Both blue AND yellow lights are now on.
  2. Hold the Cycle button for 5 seconds. Yellow light turns off, blue light remains lit.
  3. Press the Reset button to clear this status and proceed to troubleshoot.

Why is my Litter-Robot not connecting to my phone?

Please make sure you’re using the latest versions your phone’s software/system: Apple (iOS 10.0 and higher) or Android (8.0 and higher). iPhone users: Try onboarding with your Bluetooth enabled. … Android users: Androids have a Smart Network Switch that interferes with the connection to the Litter-Robot hotspot.

How do you fix the Litter-Robot offline?

Please try the following: Perform a hard reset on your Litter-Robot: Unplug the unit from the back of the base, wait 1 minute, then plug it back in and allow it to cycle. Check the app – if it still shows offline, please move on to the next step. Reboot your router.

THIS IS UNIQUE:  Question: What is Artificial Intelligence How can it help a country's government in making decisions?

What does it mean when Litter-Robot is offline?

We need to perform a hard reset on the Litter-Robot. While the unit is powered ON, unplug the Litter-Robot by removing the power jack from the back of the base without turning the Robot off. Wait 10-15 seconds, and plug it back in. … You may need to move your router closer to your Litter-Robot.

Why is the blue light flashing on my Litter-Robot?

You’ll most commonly notice a flashing or blinking blue light on your Litter-Robot control panel. This blue light is called the Drawer Full Indicator, which means that the waste drawer is full (or approaching full) and needs to be emptied.

How do you Unpause a Litter-Robot?

Repeat Press & Hold to unlock. Pauses the unit during cycling or will reset Cat Sensor baseline when pushed at home position while Blue LED is illumiated (Recommended after adding litter). When paused, repeat Press & Release to resume cycle.

How do I reset my Litter Robot 2?

Make sure that the green light on the Litter-Robot Control Panel is on (“OK/Waiting”). 3. If the red light is on (“Sensor/Timing”), push any of the buttons (Cycle, Fill, or Empty). This resets the unit and the green light should come on (“OK/Waiting”).

Where is the sensor in the Litter Robot?

The Litter-Robot is equipped with infrared emitters and sensors located above the Waste Drawer that check if the drawer is full each time the Globe returns to the Home position.

Who invented the Litter-Robot?

The Story. It all began back in 1999 when Brad Baxter, Litter-Robot inventor, founder, and CEO, inherited two cats.

THIS IS UNIQUE:  Your question: What is shallow convolutional neural network?
Categories AI