If your robot cannot be found in the network, reboot the robot and router, force close the iRobot HOME App, and retry the Wi-Fi setup process. If the problem persists, check your Wi-Fi settings on your router to confirm they are compatible with the Wi-Fi setup process.
How do I reconnect my Roomba Wi-Fi?
On the Roomba itself, tap and hold the buttons with the target icon and the home icon until the Roomba makes a tone. Your vacuum will take a moment to connect to your Wi-Fi network. Once it’s done, you should see a screen like the one on the right.
How do I reset my Roomba Wi-Fi?
Press and hold HOME and SPOT Clean buttons on your robot for 10 seconds. When the button is released, Roomba will play the reboot tone. Wi-Fi connected Roomba 800 series. The reboot procedure is the same for Roomba 500 & 600 series, and also Wi-Fi connected Roomba 600 & 800 series.
Why is my Roomba not working?
The most common problem indicated by Roomba owners is its battery. … Some people advise resetting and cycling the unit, which is done by removing the battery, press down the clean button for 5 to 15 seconds, restore the battery, and charging the Roomba until the power indicator light becomes green again.
Is my Roomba WiFi enabled?
Not all Roomba models are WiFi connected so make sure you have the right model before you attempt this process. The WiFi connected models are; Roomba 690, Roomba 890, Roomba 960 and Roomba 980. You can also check your product manual for information on whether it can be connected to WiFi.
Why is my Roomba flashing orange?
The flashing orange light means it senses that the battery has been discharged and when docked it is recharging. Do not interrupt the cycle of charging the orange blinking light will cease and the unit should operate normally once charging is complete.
Why is Roomba flashing blue?
Flashing blue: Dirt Detect™ activated. Blue sweep forward: Emptying bin into Clean Base™ Automatic Dirt Disposal.
Why doesn’t my Roomba have suction?
Also, the filter could be worn out or clogged up and cause the Roomba to loose suction. If this happens when the bin is empty, the sensors are dirty. They are the rectangles extending into cutouts in the dust bin door. Wipe off both sides of the bin door and the rectangles themselves so they can see each other.